Cisco Identity Services Engine Quiz

 



Cisco Identity Services Engine Quiz contain set of 10 MCQ questions for Cisco Identity Services Engine MCQ which will help you to clear beginner level quiz.



1. Which two elements must you configure on a Cisco Wireless LAN Controller to allow Cisco ISE to authenticate wireless users? (Choose two)
A. Configure Cisco ISE as a RADIUS authentication server and enter a shared secret.
B. Configure Cisco ISE as a RADIUS accounting server and enter a shared secret.
C. Configure all attached LWAPs to use the configured Cisco ISE node.
D. Configure RADIUS attributes for each SSID.
E. Configure each WLAN to use the configured Cisco ISE node.
F. Configure the Cisco Wireless LAN Controller to join a Microsoft Active Directory domain.
 
2. Which three Cisco TrustSec enforcement modes are used to help protect network operations when securing the network? (Choose three)
A. Logging mode
B. Monitor mode
C. Semi-passive mode
D. Low-impact mode
E. Closed mode
 
 
3. Of the below options, which software could be used to determine health check / compliance of a host? (Choose two)
A. Cisco AnyConnect Profile Editor
B. Cisco AnyConnect ISE Posture Module
C. Cisco NAC Agent
D. Cisco AnyConnect Network Access Manager Module
 
 
4. Of the below options, which software should be installed on Android devices to configure 802.1x settings and configure the device to obtain a digital certificate?
A. Cisco AnyConnect VPN Module
B. Cisco AnyConnect Host Scan Module
C. Cisco NAC Agent
D. Cisco Network Setup Assistant
 
 
5. Which among these require accurate time? (Choose three)
A. EAP-TLS-based authentication
B. EAP-MS-CHAPv2-based authentication
C. Accurate posture assessment results
D. Active Directory integration
E. Consistent profiling data collection
F. Accurate and reliable logging
 
6. When does the browser get redirected in web authentication?
A. When there is a request for DNS
B. Before getting the IP address
C. When there is a request for a web page
D. When the Cisco NAC Agent reaches the Policy Service node
 
 
7. Which among the below protocols support EAP chaining?
A. EAP-PEAP
B. EAP-FAST
C. EAP-TLS
D. EAP-TTLS
 
 
8. Which two choices are valid methods of authorizing a wired supplicant? (Choose two.)
A. EAP-FAST
B. VLAN assignment
C. dACL
D. EAPOL
E. RADIUS
 
 
9. Which three of these are viable endpoint posture compliance statuses? (Choose three)
A. Unknown
B. Infected
C. Clean
D. Compliant
E. Non-compliant
F. Quarantine
 
 
10.  Which of the following three conditions can be used for posture check? (Choose three)
A. Application
B. Operating system
C. File
D. Certificate
E. Service
 
11.  Which Cisco ISE component intercepts HTTP and HTTPS requests and redirects them to the Guest Portal?
A. Policy Service Node
B. Administration Node
C. Monitoring Node
D. Network Access Device