Border Gateway Protocol | BGP Solved MCQ

 



BGP Solved MCQ contain set of 10 MCQ questions for Border Gateway Protocol MCQ which will help you to clear beginner level quiz.



 
1.   What are valid BGP terms?

1. Communities, Corporation
2. Communities, Confederation
3. Confederation, Collision
4. Collision, Communities

2.   Local preference is

1. Local to single link
2. Common to multiple AS
3. Local to single router
4. Local to a single AS

3.  When selecting the best path, the BGP protocol takes into account the following info in the stated order

1. Pathà Origin type à Multi-exit discriminatorà Local Preference
2. Local Preference à Path à Origin type à Multi-exit discriminator
3. Local Preference à Origin type à Path à Multi-exit discriminator
4. None

4. What does next hop of 0.0.0.0 mean in the Show ip bgp command output

1. The network is locally originated via redistribution of EGP into IGP
2. The network is locally originated via redistribution of IGP into BGP
3. The network is locally originated via redistribution of external routes into OSPF
4. The network is redistributed from BGP into OSPF

5.  Is there any special configuration needed on PIX/ASA to allow BGP sessions through it?

1. Yes
2. No
3. May Be
4. Strictly None

6. What is the BGP default ConnectRetry timer and is it possible to Tune?

1. 180 and Yes
2. 180 and No
3. 120 and Yes
4. 120 and No

7.   What does the %IPRT-3-ROUTEINSERTERROR:Error inserting routing entry error message mean?

1. Not enough memory to accommodate configured BGP static routes
2. Route already presents in the routing table
3. Not enough memory to accommodate BGP prefixes learnt from neighbors
4. ACL blocking routes to be inserted into routing table
    

8.  What is the command to check ipv6 BGP neighbors?

1. Show ip bgp summary
2. Show ipv6 bgp summary
3. Show ipv6 bgp unicast summary
4. Show bgp ipv6 unicast summary

9.    BGP message types,

1. Open, update, keepalive, Notification
2. Open, sync, keepalive, notification
3. Open, update, sync, ACK, notification
4. Open, update, keepalive, ACK, notification
    

10.   When does BGP uses 0.0.0.0 as Router ID

1. When there is single loopback interface even not configured
2. When there is no interfaces available with IP address
3. Same IP configured on Loopback and Physical interface
4. No adjacency is detected or neighbor is down