CCNA Quiz
CCNA Quiz contain set of 10 MCQ questions for CCNA MCQ which will help you to clear beginner level quiz.
1) What is the maximum number of IP addresses that can be assigned to hosts on a local subnet that uses the 255.255.255.224 subnet mask?
A. 14
B. 15
C. 16
D. 30
2) To test the IP stack on your local host, which IP address would you ping?
A. 127.0.0.0
B. 1.0.0.127
C. 127.0.0.1
D. 127.0.0.255
3) Which statement(s) about IPv6 addresses are true?
- Leading zeros are required.
- Two colons (::) are used to represent successive hexadecimal fields of zeros.
- Two colons (::) are used to separate fields.
- A single interface will have multiple IPv6 addresses of different types
A. 1 and 3
B. 2 and 4
C. 1, 3 and 4
D. All of the above
4) What is the administrative distance of OSPF?
A. 90
B. 100
C. 110
D.120
5) What are reasons for creating OSPF in a hierarchical design?
A. To decrease routing overhead
B. To speed up convergence
C. To confine network instability to single areas of the network
D. To make configuring OSPF easier
6) What command do you type to save the configuration stored in RAM to NVRAM?
A. Router(config)#copy current to starting
B. Router#copy starting to running
C. Router(config)#copy running-config startup-config
D. Router#copy run startup
7) A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next?
A. It checks the configuration register
B. It attempts to boot from a TFTP server
C. It loads the first image file in flash memory
D. It inspects the configuration file in NVRAM for boot instructions
8) What does a Layer 2 switch use to decide where to forward a received frame?
A. source MAC address
B. source IP address
C. source switch port
D. destination IP address
E. destination port address
F. destination MAC address
9) VLAN 3 is not yet configured on your switch. What happens if you set the switchport access vlan 3 command interface configuration mode?
A. The command is accepted and the respective VLAN is added to vlan.dat.
B. The command is rejected.
C. The command is accepted and you must configure the VLAN manually.
D. The port turns amber.
10) A network engineer wants to allow a temporary entry for a remote user with a specific username and password so that the user can access the entire network over the internet. Which ACL can be used?
A. reflexive
B. extended
C. standard
D. dynamic
11) What authentication type is used by SNMPv2?
A. HMAC-MD5
B. HMAC-SHA
C. CBC-DES
D. community strings
